Cisco Cisco Packet Data Gateway (PDG)
ACS Bandwidth Policy Configuration Mode Commands
▀ flow limit-for-bandwidth
▄ Command Line Interface Reference, StarOS Release 17
382
flow limit-for-bandwidth
This command allows you to configure the flow limit-for-bandwidth parameter for the current bandwidth policy.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Bandwidth Policy Configuration
active-charging service service_name > bandwidth-policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-bandwidth-policy)#
Syntax
flow limit-for-bandwidth id bandwidth_id group-id group_id
no flow limit-for-bandwidth id bandwidth_id
no
If previously configured, removes the specified flow limit-for-bandwidth configuration in the current
bandwidth policy.
bandwidth policy.
id bandwidth_id
Specifies ID for the current bandwidth policy.
bandwidth_id
must be an integer from 1 through 65535.
group-id group_id
Specifies group ID for the current bandwidth policy.
group_id
must be an integer from 1 through 65535.
Usage
Use this command to configure the flow limit-for-bandwidth configuration for a bandwidth policy.
Example
The following command configures the Flow Limit-for-Bandwidth configuration with bandwidth policy ID
test123
and group ID
123
:
flow limit-for-bandwidth id test123 group-id 123