Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (T-threshold phspc)
task facility mmedemux ▀
Command Line Interface Reference, StarOS Release 17 ▄
5521
task facility mmedemux
Configures wait-time and percentage parameters related to the MMEDEMUX. The MMEDEMUX distributes the
incoming traffic to the associated MMEMGRs based on the percentage value and wait-time configured in this
command.
incoming traffic to the associated MMEMGRs based on the percentage value and wait-time configured in this
command.
Product
MME.
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
task facility mmedemux mmemgr-startup-percentage percent_value [ mmemgr-startup-wait-time
wait_time ]
wait_time ]
[ default | no ] task facility mmedemux mmemgr-startup-percentage mmemgr-startup-wait-
time
time
[ default | no ]
Either of these command filters disables the operator defined configuration and replaces the configuration
with default values.
with default values.
mmemgr-startup-percentage percent_value
The percentage parameter allows the operator to configure the percentage of MMEMGRs to be associated
with the MMEDEMUX.
with the MMEDEMUX.
percent_value
must be an integer from 1 to 100. Default is 90%.
mmemgr-startup-wait-time wait_time
This parameter enables the operator to configure the time (in seconds) that the MMEDEMUX waits for
MMEMGRs to start before processing incoming traffic.
MMEMGRs to start before processing incoming traffic.
wait_time
must be an integer from 300 to 3600. Default is 600 (10 minutes).
Usage
This command gives operators some control over the MMEDEMUX system. It allows operators to configure
the percentage of MMEMGRs to be associated with the MMEDEMUX. It also assigns the waiting time
before processing the incoming traffic. Incoming traffic is distributed to the MMEMGRs based on a
combination of the configured values of the two parameters.
By default, the MME waits for ten minutes to check if 90% of the MMEMGRs have started.
the percentage of MMEMGRs to be associated with the MMEDEMUX. It also assigns the waiting time
before processing the incoming traffic. Incoming traffic is distributed to the MMEMGRs based on a
combination of the configured values of the two parameters.
By default, the MME waits for ten minutes to check if 90% of the MMEMGRs have started.
Example