Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll aaa-acct-failure interval ▀
Command Line Interface Reference, StarOS Release 17 ▄
5715
threshold poll aaa-acct-failure interval
Configures the polling interval over which to count failed AAA accounting requests.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll aaa-acct-failure interval duration
default threshold poll aaa-acct-failure interval
default
Restores the specified parameter to its default value 300 seconds.
interval
duration
Default: 300 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
is an integer from 60 through 60000 in multiples of 30.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshAAAAcctFail
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the AAA accounting failure
threshold:
threshold poll aaa-acct-failure interval 600