Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll dcca-bad-answers interval
▄ Command Line Interface Reference, StarOS Release 17
5760
threshold poll dcca-bad-answers interval
Configures the polling interval for DCCA Bad Answers threshold—invalid or bad response to the system from the
Diameter server.
Diameter server.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll dcca-bad-answers interval duration
default threshold poll dcca-bad-answers interval
default
Uses the default threshold polling interval.
Default: 900 seconds
Default: 900 seconds
interval duration
Specifies the polling interval (in seconds) for the DCCA Bad Answers threshold.
duration
must be an integer from 60 through 60000.
Usage
This command configures the poling interval for DCCA Bad Answers threshold.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholding in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshDCCABadAnswers
command in this mode.
Example
The following command configures the polling interval to
600
seconds for invalid or bad response threshold
to the system from Diameter server: