Cisco Cisco Packet Data Gateway (PDG)
ACS Group-of-Ruledefs Configuration Mode Commands
▀ dynamic-command
▄ Command Line Interface Reference, StarOS Release 17
596
dynamic-command
This command allows you to add or remove dynamic commands from a group-of-ruledefs.
Product
ACS
CF
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > ACS Group-of-Ruledefs Configuration
active-charging service service_name > group-of-ruledefs group_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-group-of-ruledefs)#
Syntax
dynamic-command content-filtering category policy-id policy_id
no dynamic-command content-filtering category policy-id
no
Specifies to remove dynamic command configuration from the current group-of-ruledefs.
content-filtering category policy-id policy_id
Specifies the dynamic command for Content Filtering Category Policy ID configuration.
policy_id
must be a Content Filtering Category Policy ID, and must be an integer from 1 through
4294967295.
Usage
Use this command to add a dynamic command to a group-of-ruledefs, which will be executed when a
dynamic protocol specifies that group-of-ruledefs (via the Rulebase-Name AVP).
dynamic protocol specifies that group-of-ruledefs (via the Rulebase-Name AVP).
Important:
This release supports only one command option, which is
dynamic-command content-
filtering category policy-id policy_id
Example
The following command configures a dynamic command for Content Filtering Category Policy ID
configuration using the policy ID
configuration using the policy ID
100
:
dynamic-command content-filtering category policy-id 100