Cisco Cisco Packet Data Gateway (PDG)
HNB-CS Network Configuration Mode Commands
map nri ▀
Command Line Interface Reference, StarOS Release 17 ▄
6323
map nri
Configures the mapping of Network Resource Identifier (NRI) sent from UE to the MSC point code. This is an
important configuration for CS network resource sharing over Iu-Flex interface.
important configuration for CS network resource sharing over Iu-Flex interface.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > HNB-CS Network Configuration
configure > cs-network cs_instance
Entering the above command sequence results in the following prompt:
[local]host_name(config-cs-network-instance_id)#
Syntax
map nri range nri_start to nri_end point-code msc_point_code
no map nri range nri_start to nri_end
no
Removes the entries of mapping of range of NRIs received from UE with particular MSC point code.
range nri_start
to
nri_end
Specifies the range of NRIs received from UE to map with pa articular MSC point code during initial CS core
network node selection.
network node selection.
nri_start
is an integer from 0 through 1023 that should be less than
nri_end
.
nri_end
is an integer from 0 through 1023 that should be more than
nri_start
.
The command can be entered more than once to map multiple NRI ranges to same MSC, but overlapping is
not allowed.
not allowed.
point-code msc_point_code
Specifies the SS7 address of the MSC in the CS network to map with a range of NRI values.
point_code
is an SS7 point code in dotted-decimal ###.###.### or 8-digit decimal ######## format.
Usage
Use this command to map a NRI received from UE during initial CS network node selection to MSC point
code through NRI range mapping over Iu-Flex interface.
This configuration is used during initial CS core network node selection when the network resource identifier
(NRI) from the UE is available. The NRI range is mapped to MSC point code. This configuration is used
when the core network uses Iu-Flex interface.
The command can be entered more than once to map multiple NRI ranges to same MSC point code.
It is possible to configure multiple ranges to more than one MSC however this configuration is required only
when the CS core network is configured as Multi-Operator Core Network (MOCN).
code through NRI range mapping over Iu-Flex interface.
This configuration is used during initial CS core network node selection when the network resource identifier
(NRI) from the UE is available. The NRI range is mapped to MSC point code. This configuration is used
when the core network uses Iu-Flex interface.
The command can be entered more than once to map multiple NRI ranges to same MSC point code.
It is possible to configure multiple ranges to more than one MSC however this configuration is required only
when the CS core network is configured as Multi-Operator Core Network (MOCN).