Cisco Cisco Packet Data Gateway (PDG)
PCC-Action-Set Configuration Mode Commands
▀ usage-monitor
▄ Command Line Interface Reference, StarOS Release 17
7556
usage-monitor
This command sets an action to allow operator to stop, reset or start the counting for a PCC-Usage-Monitor in PCC-
Action-Set configuration for PCC-Service instance.
Action-Set configuration for PCC-Service instance.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Action-Set Configuration
configure > context context_name > pcc-service service_name > action-set action_set_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-action-set)#
Syntax
[no] usage-monitor usage_mon_name {reset-counter | start-counter | stop-counter}
no
Removes the action to allow operator to stop, reset or start the counting for a PCC-Usage-Monitor in PCC-
Action-Set configuration for PCC-Service instance.
Action-Set configuration for PCC-Service instance.
usage_mon_name
Specifies the name of the pre-configured PCC-Usage-Monitor for which counter action is configured under
PCC-Action-Set configuration instance for PCC-Service configuration.
PCC-Action-Set configuration instance for PCC-Service configuration.
usage_mon_name
is a pre-configured PCC-Usage-Monitor.
reset-counter
Resets the usage counts for PCC-Usage-Monitor under PCC-Action-Set configuration instance for PCC-
Service configuration.
Service configuration.
start-counter
Starts the accumulation of usage counts for PCC-Usage-Monitor under PCC-Action-Set configuration
instance for PCC-Service configuration.
instance for PCC-Service configuration.
stop-counter
Stops the accumulation of usage counts for PCC-Usage-Monitor under PCC-Action-Set configuration
instance for PCC-Service configuration.
instance for PCC-Service configuration.
Usage
Use this command to set an action to allow operator to stop, reset or start the counting for a usage monitor in
PCC-Action-Set configuration for PCC-Service instance.
PCC-Action-Set configuration for PCC-Service instance.
Example