Cisco Cisco Packet Data Gateway (PDG)
Remote Address List Configuration Mode Commands
▀ address
▄ Command Line Interface Reference, StarOS Release 17
8112
address
Configures addresses within a Remote Address List.
Product
PDSN
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Remote Address List Configuration
configure > context context_name > radius accounting ip remote-address list list_number
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-remaddr-list)#
Syntax
[ no ] address ip_address netmask subnet
no
Removes a previously configured address.
ip_address
Specifies the IP address of the remote device.
ip_address
is entered using IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
netmask subnet
Specifies the subnet mask of the remote device.
subnet
is the netmask expressed in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
Usage
Use this command to configure remote address lists for use with the Remote Address-based accounting
feature. A maximum of 10 address can be configured per list.
feature. A maximum of 10 address can be configured per list.
Example
The following command adds an IP address of
192.168.100.1
with a subnet mask of
255.255.255.0
to
the list:
address 192.168.100.1 netmask 255.255.255.0