Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
▀ fw-and-nat policy
▄ Command Line Interface Reference, StarOS Release 17
8732
fw-and-nat policy
Important:
This command is only available in StarOS 8.1. This customer-specific command must be used to
configure the Policy-based Firewall-and-NAT feature.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
fw-and-nat policy fw_nat_policy
{ default | no } fw-and-nat policy
default
Specifies that the default Firewall-and-NAT policy configured in the rulebase be used for the subscriber.
no
Disables Firewall and NAT processing for the subscriber.
fw_nat_policy
Specifies the Firewall-and-NAT policy for the subscriber.
fw_nat_policy
must be an alphanumeric string of 1 through 63 characters. Note that this policy will
override the
default Firewall-and-NAT policy
configured in the ACS rulebase.
Usage
Use this command to configure the Firewall-and-NAT policy for subscribers. Note that the policy configured
in the subscriber mode will override the default policy configured in the ACS rulebase. If a policy is not
configured in the subscriber mode, the default policy configured in the ACS rulebase will be applied.
in the subscriber mode will override the default policy configured in the ACS rulebase. If a policy is not
configured in the subscriber mode, the default policy configured in the ACS rulebase will be applied.
Example
The following command configures a Firewall-and-NAT policy named
standard
for the subscriber:
fw-and-nat policy standard