Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
pop3 pdu-length ▀
Command Line Interface Reference, StarOS Release 17 ▄
1021
pop3 pdu-length
This command allows you to define rule expressions to match the Protocol Data Unit (PDU) length of POP3 packets
equal to the POP3 header plus POP3 payload.
equal to the POP3 header plus POP3 payload.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] pop3 pdu-length { operator pdu_length | { { range | !range } range_from to
range_to } }
range_to } }
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
{ range | !range } range_from to range_to
Enables or disables the range criteria.
range
: Enables the range criteria.
!range
: Disables the range criteria.
range_from
: Specifies the start of range as an integer from 0 through 65535.
range_to
: Specifies the end range.
range_to
must be an integer from 0 through 65535, and must be
greater than
range_from
.
pdu_length
Specifies the POP3 PDU length to match.
pdu_length
must be an integer from 0 through 65535.