Cisco Cisco Packet Data Interworking Function (PDIF)
APN Configuration Mode Commands
▀ timeout idle
▄ Command Line Interface Reference, StarOS Release 17
1454
timeout idle
Configures the idle timeout duration for the long duration timer associated with a subscriber session.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
timeout idle idle_dur [ del-cause { none | reactiv-req } ]
[ default | no ] timeout idle [ del-cause ]
default | no
Indicates the timeout specified is to be returned to its default behavior. If no specific timeout is specified, then
all are set to their default behavior.
all are set to their default behavior.
idle_dur
Default: 0
Designates the maximum duration of the session (in seconds). After expiry the system considers the session
as dormant or idle and terminates the session.
Designates the maximum duration of the session (in seconds). After expiry the system considers the session
as dormant or idle and terminates the session.
idle_dur
must be an integer value in the range from 0 through 4294967295.
The special value 0 disables the timeout specified.
del-cause { none | reactiv-req }
When subscribers are deleted due to APN timeouts, the GGSN/P-GW/SAEGW may include “Cause-IE” in
the resulting Delete Bearer/Delete PDP Context Requests generated for default bearer.
the resulting Delete Bearer/Delete PDP Context Requests generated for default bearer.
none
: Omit GTP “Cause-IE” in DBR/DPC when timeout occurs on default bearer.
reactiv-req
: The DBR/DPC will include “Cause-IE” with GTP cause code “Reactivation Requested”.
This behavior is applicable only if Delete Bearer Request is sent for default bearer, or Delete PDP Context is
sent to delete the PDN connection or its last PDP context.
The behavior for “Cause-IE” specified in this CLI shall override the cause-code set by existing features.
By default, the
sent to delete the PDN connection or its last PDP context.
The behavior for “Cause-IE” specified in this CLI shall override the cause-code set by existing features.
By default, the
del-cause
option is not defined and existing behavior is retained.
Important:
This option is only valid when Cause IE Enhancement for Delete Bearer Request license is enabled.
Contact your Cisco account representative for more information.