Cisco Cisco Packet Data Interworking Function (PDIF)
APN Profile Configuration Mode
ip access-group ▀
Command Line Interface Reference, StarOS Release 17 ▄
1509
ip access-group
Configure the name of the access control list (ACL) for incoming and outgoing packets.
Product
SaMOG
Privilege
Administrator
Mode
Exec > Global Configuration > APN Profile Configuration
configure > apn-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(apn-profile-profile_name)#
Syntax
[ no ] ip access-group group_name [ in | out ]
no
If previously configured, removes the IP access group.
group_name
group_name
must be an alphanumeric string of 1 to 47 characters.
in | out
Specify the access group as inbound or outbound.
Usage
Use this command to configure the ACL name for incoming and outgoing packets to redirect HTTP packtes,
allow DNS packets and drop other packets. The IP access group specified in this configuration will be used
only if the AAA server does not specify the same during authentication.
allow DNS packets and drop other packets. The IP access group specified in this configuration will be used
only if the AAA server does not specify the same during authentication.
Important:
This command is license dependent. Contact your Cisco account representative for more information
on SaMOG feature license requirements.
Example
The following command configures an IP access group called
webauthaccgroup
and sets it as inbound:
ip access-group webauthaccgroup in