Cisco Cisco Packet Data Interworking Function (PDIF)
Command Line Interface Reference, StarOS Release 17 ▄
1573
Chapter 26
ARP-RP Mapping Profile Configuration Mode
The commands in this mode configure the various parameters of the ARP-RP Mapping Profile.
The SGSN uses the ARP to RP mapping for a variety of reasons, such as choosing a preferred radio priority according
to the ARP values sent by the GGSN and HLR. These mappings will be used by corresponding 2G and/or 3G services
to choose the radio priority value sent in downlink messages towards the MS/UE:
to the ARP values sent by the GGSN and HLR. These mappings will be used by corresponding 2G and/or 3G services
to choose the radio priority value sent in downlink messages towards the MS/UE:
Activate PDP Accept.
Modify PDP Request during network-initiated PDP modification procedure.
Modify PDP Accept during MS-initiated PDP modification procedure provided the ARP has been changed by
the network.
Mode
Exec > Global Configuration > SGSN Global Configuration > ARP-RP Mapping Profile Configuration
configure > sgsn-global > qos-arp-rp-map-profile arp-rp_prof_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-arp-rp-map-profile-arp-rp_prof_name)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).