Cisco Cisco Packet Data Interworking Function (PDIF)
ATM Port Configuration Mode Commands
toh-sdsf ▀
Command Line Interface Reference, StarOS Release 17 ▄
1597
toh-sdsf
Enable/disable line SDSF BER thresholds and configure the line transport overhead (TOH) signal degrade and signal
failure (SDSF) bit error rate (BER) threshold.
failure (SDSF) bit error rate (BER) threshold.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > ATM Port Configuration
configure > port atm slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
toh-sdsf toh_value
default toh-sdsf
default
Resets the default which disables this threshold.
toh_value
To facilitate configuration the SD and SF rates have been combined into a single setting.
0: Disabled
1 - 1.E-04
2 - 1.E-05
3 - 1.E-06
4 - 1.E-07
5 - 1.E-08
6 - 1.E-09
7 - 1.E-10
8 - 1.E-11
Usage
This command is typically configured in combination with configuring APS/MSP redundancy for the line
card - see the
card - see the
aps
and the
redundancy
commands documented in the Card Configuration Mode Commands
chapter..
This command can be used to configure the line threshold whether the port is active or standby and sets a
standard option for the paired values of the line’s signal degrade and signal failure (SDSF) BER.
This command can be used to configure the line threshold whether the port is active or standby and sets a
standard option for the paired values of the line’s signal degrade and signal failure (SDSF) BER.