Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands I-M
▀ ipv6 rri-route
▄ Command Line Interface Reference, StarOS Release 17
2584
ipv6 rri-route
Configures High Availability (HA) IPv6 routing parameters for Reverse Route Injection (RRI). (VPC-VSM only)
Product
SecGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
ipv6 rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ipv6_address
} { ipv6_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
} { ipv6_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no ipv6 rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip
virtual_ipv6_address } { ipv6_address | next-hop nexthop_address } interface
interface_name [ vrf vrf_name ]
virtual_ipv6_address } { ipv6_address | next-hop nexthop_address } interface
interface_name [ vrf vrf_name ]
no
Disables the specified RRI route.
network-mode { L2 | L3 }
Specifies the RRI route network mode type as Layer 2 (L2) or Layer 3 (L3).
clear_loopback_ip
Specifies the loopback address for clear traffic in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal
notation.
notation.
rri-ip
virtual_ipv6_address
Specifies the use of a virtual IP address on both Primary and Secondary for RRI.
virtual_ipv6_address
is expressed in IPv6 colon-separated-hexadecimal notation.
ipv6_address
Specified in IPv6 colon-separated-hexadecimal notation.
next-hop
nexthop_address
Next hop address specified in IPv6 colon-separated-hexadecimal notation. The next hop IP address is not
required for point-to-point and tunnel interfaces.
required for point-to-point and tunnel interfaces.