Cisco Cisco Packet Data Interworking Function (PDIF)
Context Configuration Mode Commands S-Z
threshold ip-pool-hold ▀
Command Line Interface Reference, StarOS Release 17 ▄
2771
threshold ip-pool-hold
Sets an alert based on the percentage of IP addresses from an IP pool that are on hold. This command affects all IP pools
in the current context.
in the current context.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
threshold ip-pool-hold high_thresh [ clear low_thresh ]
default threshold ip-pool-hold
default
Configures the default setting.
high_thresh
Sets the high threshold percentage of addresses on hold in an IP pool that must be met or exceeded within the
polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 100. Default: 0
polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 100. Default: 0
clear low_thresh
Sets the low threshold percentage of addresses on hold in an IP pool that maintains a previously generated
alarm condition. If the utilization percentage rises below the low threshold within the polling interval, a clear
alarm will be generated. It may be configured as an integer from 0 through 100. Default: 0
alarm condition. If the utilization percentage rises below the low threshold within the polling interval, a clear
alarm will be generated. It may be configured as an integer from 0 through 100. Default: 0
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set an alert or an alarm when the percentage of IP addresses on hold in any pool is equal
to or greater than a specified percentage of the total number of addresses in the pool.
Alerts or alarms are triggered for percentage of IP address pool addresses on hold based on the following
rules:
to or greater than a specified percentage of the total number of addresses in the pool.
Alerts or alarms are triggered for percentage of IP address pool addresses on hold based on the following
rules:
Enter Condition: Actual percentage of IP addresses on hold per pool > High Threshold
Clear Condition: Actual percentage of IP addresses on hold per pool < Low Threshold