Cisco Cisco Packet Data Interworking Function (PDIF)
Credit Control Configuration Mode Commands
▀ diameter disable-final-reporting-in-ccru
▄ Command Line Interface Reference, StarOS Release 17
2792
diameter disable-final-reporting-in-ccru
This command controls sending of CCR-U with reporting reason as FINAL immediately on receiving a 4012 or 4010
result-code at MSCC level.
result-code at MSCC level.
Important:
In StarOS release 16.0 and later, this command is obsolete and is only supported for backward
compatibility reasons. Release 16.0 and beyond, use the diameter msg-type { ccru| ccrt } suppress-final-reporting
command for this functionality.
command for this functionality.
Product
GGSN
HA
IPSG
PDSN
P-GW
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Credit Control Configuration
active-charging service service_name > credit-control
Entering the above command sequence results in the following prompt:
[local]host_name(config-dcca)#
Syntax
diameter disable-final-reporting-in-ccru
{ default | no } diameter disable-final-reporting-in-ccru
default | no
Configures this command with the default setting. Default behavior is to send CCR-U with reporting reason
as FINAL immediately on receiving 4010/4012 result-code.
as FINAL immediately on receiving 4010/4012 result-code.
Usage
As per the current implementation, CCR-U is sent immediately on receiving 4010 or 4012 Result-Code at
MSCC level. This new CLI command controls sending of immediate CCR-U with FINAL as Reporting-
Reason. All other behaviors remain almost same like a Rating-group being blacklisted.
If this CLI command is configured, on receiving the result-code 4010/4012 at MSCC-level, immediate CCR-
U with FINAL as Reporting-Reason will not be sent. All USU corresponding to that rating group is reported
in CCR-T message.
MSCC level. This new CLI command controls sending of immediate CCR-U with FINAL as Reporting-
Reason. All other behaviors remain almost same like a Rating-group being blacklisted.
If this CLI command is configured, on receiving the result-code 4010/4012 at MSCC-level, immediate CCR-
U with FINAL as Reporting-Reason will not be sent. All USU corresponding to that rating group is reported
in CCR-T message.
Example
The following command specifies not to send immediate CCR-U with FINAL as Reporting-Reason:
diameter disable-final-reporting-in-ccru