Cisco Cisco Packet Data Interworking Function (PDIF)
Diameter Endpoint Configuration Mode Commands
dynamic-peer-failure-retry-count ▀
Command Line Interface Reference, StarOS Release 17 ▄
3513
dynamic-peer-failure-retry-count
This command configures the number of times the system will attempt to connect to a dynamically discovered Diameter
peer.
peer.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Diameter Endpoint Configuration
configure > context context_name > diameter endpoint endpoint_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-diameter)#
Syntax
dynamic-peer-failure-retry-count no_of_retries
default dynamic-peer-failure-retry-count
default
Configures this command with the default setting.
Default: 8
Default: 8
no_of_retries
Specifies the number of retry attempts to connect to a dynamically discovered Diameter peer. The value must
be an integer from 0 through 255.
be an integer from 0 through 255.
Usage
Use this command to configure the number of times the system attempts to connect to a dynamically
discovered Diameter peer.
After the specified number of attempts if the peer is still not open, the peer is moved into blacklist and other
peers are tried. The blacklisted peer will be retried after a time period of one hour.
discovered Diameter peer.
After the specified number of attempts if the peer is still not open, the peer is moved into blacklist and other
peers are tried. The blacklisted peer will be retried after a time period of one hour.
Example
The following command sets the retry attempts to
10
:
dynamic-peer-failure-retry-count 10