Cisco Cisco Packet Data Interworking Function (PDIF)
Diameter Endpoint Configuration Mode Commands
▀ reconnect-timeout
▄ Command Line Interface Reference, StarOS Release 17
3528
reconnect-timeout
This command configures the time interval after which the Diameter peer will be reconnected automatically when
DO_NOT_WANT_TO_TALK_TO_YOU disconnect cause is received.
DO_NOT_WANT_TO_TALK_TO_YOU disconnect cause is received.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Diameter Endpoint Configuration
configure > context context_name > diameter endpoint endpoint_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-diameter)#
Syntax
reconnect-timeout timeout
no reconnect-timeout
no
Disables auto reconnect of peer after receiving the disconnect cause
"DO_NOT_WANT_TO_TALK_TO_YOU".
The default configuration is
"DO_NOT_WANT_TO_TALK_TO_YOU".
The default configuration is
no reconnect-timeout
. The connection to peer will not be retried until it is
enabled by the administrator using the
diameter enable endpoint
command in the Exec mode.
timeout
Specifies the reconnect timeout duration in seconds, and must be an integer from 30 through 86400.
Usage
Use this command to configure a timer which is started at the reception of the
"DO_NOT_WANT_TO_TALK_TO_YOU" disconnect cause from the Diameter peer in Disconnect-Peer-
Request message. After the timer expiry, the Diameter endpoint will automatically try to reconnect to the
disconnected peer.
Currently in the system, the "DO_NOT_WANT_TO_TALK_TO_YOU " in the disconnect peer request is
treated as an admin disable. Hence when the system gets into this state the connection will not be retried and
the connection must be enabled by the administrator using the
"DO_NOT_WANT_TO_TALK_TO_YOU" disconnect cause from the Diameter peer in Disconnect-Peer-
Request message. After the timer expiry, the Diameter endpoint will automatically try to reconnect to the
disconnected peer.
Currently in the system, the "DO_NOT_WANT_TO_TALK_TO_YOU " in the disconnect peer request is
treated as an admin disable. Hence when the system gets into this state the connection will not be retried and
the connection must be enabled by the administrator using the
diameter enable endpoint
command in
the Exec mode.
Example
The following command sets the reconnect timeout to
100
seconds:
reconnect-timeout 100