Cisco Cisco Packet Data Interworking Function (PDIF)
Ethernet Port Configuration Mode Commands
ingress-mode ▀
Command Line Interface Reference, StarOS Release 17 ▄
3729
ingress-mode
Labels this port as an ingress port (incoming traffic).
Product
IPSG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
[ no ] ingress-mode
no
Disables ingress port tag.
Usage
Use this command to label this port in order for the session manager to recognize the interface from which IP
data packets are being received. This command should be used in single context configurations. In single
context configurations, the ingress port can only be identified if labeled.
data packets are being received. This command should be used in single context configurations. In single
context configurations, the ingress port can only be identified if labeled.
Important:
It is recommended to enable the
ingress-mode
configuration for IPv6 traffic to avoid packet
drops.