Cisco Cisco Packet Data Interworking Function (PDIF)
Ethernet Port Configuration Mode Commands
srp virtual-mac-address ▀
Command Line Interface Reference, StarOS Release 17 ▄
3739
srp virtual-mac-address
Configures the Standby Router Protocol (SRP) virtual MAC address for the port on an ICSR chassis.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
srp virtual-mac-address mac_address
no srp virtual-mac-address
no
Disables the SRP virtual MAC addressing for Ethernet ports. The block of virtual MAC addresses is not
saved.
saved.
mac_address
Enables SRP virtual addressing for the specified MAC address. The MAC address hsould be specified as six
groups of two hexadecimal digits separated by hyphens. For example, 01-23-45-67-89-ab.
groups of two hexadecimal digits separated by hyphens. For example, 01-23-45-67-89-ab.
Usage
The SRP virtual MAC address is applied to the port when the chassis is in SRP ACTIVE state. The default is
no srp virtual-mac-address
.
Important:
This command is not supported on all platforms.
Example
Use the following command to enable the SRP’s virtual MAC addressing:
srp virtual-mac-address 09-33-48-67-99-ae