Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Charging Action Configuration Mode Commands
charge-units ▀
Command Line Interface Reference, StarOS Release 17 ▄
393
charge-units
This command allows you to configure the charge units for RADIUS/DCCA charging calculation.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-charging-action)#
Syntax
charge-units units
{ default | no } charge-units
default
Configures this command with its default setting.
Default: 0; disables the counter, same as
Default: 0; disables the counter, same as
no charge-units
no
If previously configured, disables the charge-units configuration in the current charging action.
units
Specifies the service-specific fixed unit counter per content ID for RADIUS/DCCA charging.
units
is the value set for charging unit, and must be an integer from 1 through 65535.
Usage
This command configures the unit amount counters for charging calculation on per content ID basis for
different protocols and packets regardless of packet direction (uplink or downlink).
different protocols and packets regardless of packet direction (uplink or downlink).
Important:
For more information on content ID, refer to the
if-protocol
command in the ACS Ruledef
Configuration Mode Commands chapter.
Example
The following command sets the charging unit to
1024
:
charge-units 1024