Cisco Cisco Packet Data Interworking Function (PDIF)
Exec Mode show Commands (A-C)
show boot ▀
Command Line Interface Reference, StarOS Release 17 ▄
4383
show boot
Displays information on the current boot image in use.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
show boot [ initial-config | { grep grep_options | more } ]
initial-config
Identifies the OS image, configuration file, and boot priority used during the initial start up of the system.
| { grep grep_options | more }
Pipes (sends) the output of this command to the specified command. You must specify a command to which
the output of this command will be sent.
For details on the usage of
the output of this command will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter.
Usage
Show the boot information in preparing for maintenance activities by verifying current boot data. The boot
image in use may not be the same as the boot image stored on the SMC due to upgrades and pending reboots.
image in use may not be the same as the boot image stored on the SMC due to upgrades and pending reboots.
show boot initial-config
displays the actual boot image and configuration file loaded during boot.
This may or may not be the highest priority image and makes this command useful when comparing the
loaded image to the priority list.
loaded image to the priority list.
Important:
This command is not supported on all platforms.
Example
The following command displays the boot system configuration priority list:
show boot
The following command displays the initial configuration after a system boot:
show boot initial-config