Cisco Cisco Packet Data Interworking Function (PDIF)
Firewall-and-NAT Policy Configuration Mode Commands
▀ firewall tcp-partial-connection-timeout
▄ Command Line Interface Reference, StarOS Release 17
5080
firewall tcp-partial-connection-timeout
This command configures action on idle timeout for partially open TCP connections.
Product
PSF
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-policy)#
Syntax
firewall tcp-partial-connection-timeout timeout
{ default | no } firewall tcp-partial-connection-timeout
default
Configures the default setting.
no
Disables the idle timeout for partially open TCP connections.
timeout
Specifies the timeout in seconds.
timeout
must be an integer from 0 through 86400.
Default: 30 seconds
Usage
Use this command to configure idle timeout for TCP connections that are yet to be established (partially
open) in the case of Firewall enabled calls.
open) in the case of Firewall enabled calls.
Example
The following command sets the idle timeout setting to
30
seconds:
firewall tcp-partial-connection-timeout 30