Cisco Cisco Packet Data Interworking Function (PDIF)
Firewall-and-NAT Policy Configuration Mode Commands
firewall udp-checksum-error ▀
Command Line Interface Reference, StarOS Release 17 ▄
5085
firewall udp-checksum-error
This command configures Stateful Firewall action on packets with UDP Checksum error.
Product
PSF
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-policy)#
Syntax
firewall udp-checksum-error { drop | permit }
default firewall udp-checksum-error
default
Configures the default setting.
Default:
Default:
drop
drop
Drops packets with UDP Checksum error.
permit
Permits packets with UDP Checksum error.
Usage
Use this command to configure Stateful Firewall action on packets with UDP Checksum error.
For NAT-only calls, packets with UDP Checksum error are permitted.
For NAT-only calls, packets with UDP Checksum error are permitted.
Example
The following command specifies to drop packets with UDP Checksum error:
firewall udp-checksum-error drop