Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (A-K)
congestion-control threshold tolerance ▀
Command Line Interface Reference, StarOS Release 17 ▄
5319
congestion-control threshold tolerance
Configures the percentage under a configured threshold value that dictates the point at which the condition is cleared.
Important:
This command applies to MME (version 14.0 and higher) and ePDG (version 14.1 and higher).
Product
MME
ePDG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
congestion-control threshold tolerance { critical percent | major percent | minor percent
}
}
default congestion-control threshold system-cpu-utilization
default congestion-control threshold tolerance
Sets all threshold tolerances to the default values.
critical
percent
Default: 10
The tolerance percentage for critical thresholds. When a critical threshold drops below this level, the
condition is cleared.
The tolerance percentage for critical thresholds. When a critical threshold drops below this level, the
condition is cleared.
percent
can be configured to any integer value from 0 to 100.
major
percent
Default: 0
The tolerance percentage for major thresholds. When a major threshold drops below this level, the condition
is cleared.
The tolerance percentage for major thresholds. When a major threshold drops below this level, the condition
is cleared.
percent
can be configured to any integer value from 0 to 100.
minor
percent
Default: 0
The tolerance percentage for minor thresholds. When a minor threshold drops below this level, the condition
is cleared.
The tolerance percentage for minor thresholds. When a minor threshold drops below this level, the condition
is cleared.
percent
can be configured to any integer value from 0 to 100.