Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (L-S)
operator-policy ▀
Command Line Interface Reference, StarOS Release 17 ▄
5417
operator-policy
This command creates an operator policy and enters the operator policy configuration mode. Commands for
configuration of the policies are available in the Operator Policy Configuration Mode Commands chapter.
configuration of the policies are available in the Operator Policy Configuration Mode Commands chapter.
Product
MME
SGSN
SAEGW
S-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
operator-policy ( default | name policy_name } [ -noconfirm ]
no operator-policy ( default | name policy_name }
-noconfirm
Indicates that the command is to execute without any additional prompt and confirmation from the user.
no
Removes the specified operator policy from the system configuration.
default
default
, in this case, is the name of a specific operator policy. This default policy is used when no other
defined operator policy matches the incoming IMSI.
Important:
You should configure this default operator policy to be it available to handle IMSIs that are not
matched with other defined policies.
name policy_name
Specifies the unique name of an operator policy.
policy_name
is entered as an alphanumeric string of 1
through 64 characters.