Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold 10sec-cpu-utilization
▄ Command Line Interface Reference, StarOS Release 17
5530
threshold 10sec-cpu-utilization
Configures alarm or alert thresholds that measure a 10-second average of CPU utilization. Its polling interval can be set
down to 30 seconds.
down to 30 seconds.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold 10sec-cpu-utilization percent [ clear percent ]
percent
Default: 0
Configures Specifies the high threshold for 10-second average cpu-utilization. If the monitored CPU
utilization is greater than or equal to the specified percentage an alert is sent. Regardless of the length of the
polling interval, only one sample at the end of the polling interval is tested.
Configures Specifies the high threshold for 10-second average cpu-utilization. If the monitored CPU
utilization is greater than or equal to the specified percentage an alert is sent. Regardless of the length of the
polling interval, only one sample at the end of the polling interval is tested.
clear
percent
Default: 0:
This is a low watermark value that sets the alarm clearing threshold value. If not specified it is taken from the
first value.
This is a low watermark value that sets the alarm clearing threshold value. If not specified it is taken from the
first value.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set a threshold that sends an alert when CPU utilization over a 10-second average
exceeds the limit set.
Alerts or alarms are triggered for 10-second sample of CPU utilization based on the following rules:
exceeds the limit set.
Alerts or alarms are triggered for 10-second sample of CPU utilization based on the following rules:
Enter condition: 10-second average percentage of CPU utilization is greater than or equal to the high
threshold.
Clear condition: 10-second average percentage of CPU utilization is less than the low threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.