Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold aaa-retry-rate
▄ Command Line Interface Reference, StarOS Release 17
5544
threshold aaa-retry-rate
Configures AAA retry rate, alarm or alert thresholds for the system.
Product
PDSN
GGSN
HA
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold aaa-retry-rate high_thresh [ clear low_thresh ]
default threshold aaa-retry-rate
high_thresh
Default: 5
Specifies the high threshold percent of AAA request message retries that must be met or exceeded within the
polling interval to generate an alert or alarm.
Specifies the high threshold percent of AAA request message retries that must be met or exceeded within the
polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 100.
clear
low_thresh
Default: 5
Specifies the low threshold percent of AAA request message retries that maintains a previously generated
alarm condition. If the percentage of retries falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
Specifies the low threshold percent of AAA request message retries that maintains a previously generated
alarm condition. If the percentage of retries falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh
is an integer from 0 through 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
AAA request message retry rate thresholds generate alerts or alarms based on the percentage of request
messages (both authentication and accounting) that were retried during the specified polling interval. The
percentage is based on a message count taken for all AAA authentication and accounting servers that the
system is configured to communicate with.
Alerts or alarms are triggered for request message retries based on the following rules:
messages (both authentication and accounting) that were retried during the specified polling interval. The
percentage is based on a message count taken for all AAA authentication and accounting servers that the
system is configured to communicate with.
Alerts or alarms are triggered for request message retries based on the following rules:
Enter condition: Actual retry percentage is greater than or equal to the high threshold.