Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (T-threshold phspc)
threshold per-service-pdg-sessions ▀
Command Line Interface Reference, StarOS Release 17 ▄
5671
threshold per-service-pdg-sessions
Configures alarm or alert thresholds for the number of Packet Data Gateway (PDG) sessions per PDG service in the
system.
system.
Product
PDG/TTG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold per-service-pdg-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of PDG sessions for any one PDG service that must be met or exceeded
within the polling interval to generate an alert or alarm.
Specifies the high threshold number of PDG sessions for any one PDG service that must be met or exceeded
within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of PDG sessions for any one PDG service that maintains a previously
generated alarm condition. If the number of PDG sessions falls beneath the low threshold within the polling
interval, a clear alarm will be generated.
Specifies the low threshold number of PDG sessions for any one PDG service that maintains a previously
generated alarm condition. If the number of PDG sessions falls beneath the low threshold within the polling
interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 1000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of PDG sessions for any PDG service in the system is
equal to or greater than the set limit.
Alerts or alarms are triggered for PDSN sessions based on the following rules:
equal to or greater than the set limit.
Alerts or alarms are triggered for PDSN sessions based on the following rules:
Enter condition: Actual number of PDG sessions for any PDG service is greater than or equal to the
high threshold.
Clear condition: Actual number of PDSN sessions is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.