Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands A - N)
▀ threshold poll nat-pkt-drop
▄ Command Line Interface Reference, StarOS Release 17
5802
threshold poll nat-pkt-drop
Configures the polling interval over which to measure the percentage of Network Address Translation (NAT) packet
drops.
drops.
Product
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll nat-pkt-drop interval duration
default threshold poll nat-pkt-drop interval
default
Restores the specified poll interval value to its default value of 900 seconds.
interval duration
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 30 through 60000.
Default: 900 seconds.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
The configured polling interval will be rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other commands for additional information on the system’s
support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable [
ThreshNATPktDrop | ThreshclearNATPktDrop ]
command in this mode.
Example
The following command configures the polling interval to
500
seconds for NAT packet drops:
threshold poll nat-pkt-drop interval 500