Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold poll commands O - Z)
▀ threshold poll pdsn-init-rrq-rcvd-rate interval
▄ Command Line Interface Reference, StarOS Release 17
5812
threshold poll pdsn-init-rrq-rcvd-rate interval
Configures the polling interval over which to count the total number of current Packet Data Serving Node (PDSN)
sessions, including inactive sessions.
sessions, including inactive sessions.
Product
PDSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll pdsn-init-rrq-rcvd-rate interval duration
interval duration
Default: 0 seconds.
Specifies the amount of time (in seconds) that comprises the polling interval.
Specifies the amount of time (in seconds) that comprises the polling interval.
duration
must be an integer from 60 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholds in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshPDSNCallSetupRate
command in this mode.
Example
The following command configures the polling interval to
600
seconds for PDSN sessions:
threshold poll pdsn-init-rrq-rcvd-rate interval 600