Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
▀ threshold route-service bgp-routes
▄ Command Line Interface Reference, StarOS Release 17
5888
threshold route-service bgp-routes
Configures alarm or alert thresholds for the percentage of BGP routes.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold route-service bgp-routes high_thresh [ clear low_thresh ]
Specifies the threshold for percentage of maximum bgp routes per context. It is an integer from 0 through
100.
100.
high_thresh
Specifies the high threshold rate percentage for maximum BGP routes per context that must be met
or exceeded within the polling interval to generate an alert or alarm.
or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer
from 0 through 100. A value of 0 disables the threshold. The default value is 0.
clear low_thresh
Specifies the low threshold rate percentage for BGP routes per context that maintains a previously
generated alarm condition. If the number of BPG routes falls beneath the low threshold within the
polling interval, a clear alarm will be generated.
generated alarm condition. If the number of BPG routes falls beneath the low threshold within the
polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 100. A
value of 0 disables the threshold. The default value is 0.
For more information on the maximum route value per context, refer to Engineering Rules in the System
Administration Guide.
Administration Guide.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to configure a threshold in percentage of maximum BGP routes allowed. If the percentage
of the number of BGP routes in a context reaches
of the number of BGP routes in a context reaches
high_thresh
, a notification is generated. Optionally, if
the threshold subsystem is configured in 'alarm' mode, a Threshold_Clear notification is generated when the
percentage of the number of BGP routes in a context goes below
percentage of the number of BGP routes in a context goes below
low_thresh
. The maximum number of
BGP routes is also sent by BGP task when getting the statistics.
Alerts or alarms are triggered for BGP routes based on the following rules:
Alerts or alarms are triggered for BGP routes based on the following rules: