Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold total-hnbgw-iu-sessions ▀
Command Line Interface Reference, StarOS Release 17 ▄
5915
threshold total-hnbgw-iu-sessions
Configures alarm or alert thresholds for the total number of subscriber sessions towards the Core Networks (CN) across
all HNB-GW services over Iu interfaces (Iu-CS/Iu-PS interface) on a system.
all HNB-GW services over Iu interfaces (Iu-CS/Iu-PS interface) on a system.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold total-hnbgw-iu-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0 (Disabled)
Specifies the high threshold for the total number of subscriber sessions towards CN across all HNB-GW
services on a system that must be met or exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold for the total number of subscriber sessions towards CN across all HNB-GW
services on a system that must be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 3000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0 (Disabled)
Specifies the low threshold for the total number of subscriber sessions towards CN across all services on a
system that maintains a previously generated alarm condition. If the number of subscriber sessions falls
beneath the low threshold within the polling interval, a clear alarm will be generated.
Specifies the low threshold for the total number of subscriber sessions towards CN across all services on a
system that maintains a previously generated alarm condition. If the number of subscriber sessions falls
beneath the low threshold within the polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 3000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to monitor and set alarms or alerts when the total number of subscriber sessions towards
CN across all HNB-GW services in the system is equal to or greater than the set limit.
Alerts or alarms are triggered for the total number of subscriber sessions towards CN across all HNB-GW
service on a system based on the following rules:
CN across all HNB-GW services in the system is equal to or greater than the set limit.
Alerts or alarms are triggered for the total number of subscriber sessions towards CN across all HNB-GW
service on a system based on the following rules:
Enter condition: Actual total number of subscriber sessions across all HNB-GW service on a system is
greater than the high threshold.
Clear condition: Actual total number of subscriber sessions across all HNB-GW service on a system is
less than the low threshold.