Cisco Cisco Packet Data Interworking Function (PDIF)
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold total-mme-sessions ▀
Command Line Interface Reference, StarOS Release 17 ▄
5925
threshold total-mme-sessions
Configures alarm or alert thresholds for the total number of Mobility Management Entity (MME) sessions across all the
MME services in the system.
MME services in the system.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold total-mme-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0 (Disabled)
Specifies the high threshold number of total MME sessions that must be met or exceeded within the polling
interval to generate an alert or alarm.
Specifies the high threshold number of total MME sessions that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh
is an integer value from 0 through 2500000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0 (Disabled)
Specifies the low threshold number of total MME sessions that maintains a previously generated alarm
condition. If the number of MME sessions, across all the services in a system, falls beneath the low threshold
within the polling interval, a clear alarm will be generated.
Specifies the low threshold number of total MME sessions that maintains a previously generated alarm
condition. If the number of MME sessions, across all the services in a system, falls beneath the low threshold
within the polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 and 2500000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to monitor and set alarms or alerts when the total number of MME sessions across all the
MME services in the system is equal to or greater than the set limit.
Alerts or alarms are triggered for the total number of MME sessions based on the following rules:
MME services in the system is equal to or greater than the set limit.
Alerts or alarms are triggered for the total number of MME sessions based on the following rules:
Enter condition: Actual total number of MME sessions is greater than or equal to the high threshold.
Clear condition: Actual total number of MME sessions is less than the low threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll total-mme-sessions
command to configure the polling interval and the
threshold monitoring mme-service
command to enable thresholding for this value.