Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Packet Filter Configuration Mode Commands
▀ ip remote-port
▄ Command Line Interface Reference, StarOS Release 17
620
ip remote-port
This command allows you to configure the IP remote port(s) for the current packet filter.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Packet Filter Configuration
active-charging service service_name > packet-filter packet_filter_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-packet-filter)#
Syntax
ip remote-port { = port_number | range start_port_number to end_port_number }
no ip remote-port
no
If previously configured, deletes the ip remote-port configuration from the current packet filter.
port_number
Specifies the port number of the transport protocol.
port_number
must be the port number, and must be an integer from 1 through 65535.
range start_port_number to end_port_number
Specifies a range of port numbers.
start_port_number
and
end_port_number
must be integers from 1 through 65535.
end_port_number
must be greater than
start_port_number
.
Usage
Use this command to configure the IP remote port(s) for a packet filter.
Example
The following command configures the IP remote port as
789
:
ip remote-port = 789