Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Readdress Server List Configuration Mode
reactivation-time ▀
Command Line Interface Reference, StarOS Release 17 ▄
637
reactivation-time
This command allows you to configure the time duration (in seconds) after which the status of a previously inactive
server is rechecked.
server is rechecked.
Important:
This command is license dependent. For more information contact your Cisco account representative.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Readdress Server List Configuration
active-charging service service_name > readdress-server-list server_list_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-readdress-server-list)#
Syntax
reactivation-time reactivation_time
default reactivation-time
default
Configures this command with its default setting.
Default: 300 seconds
Default: 300 seconds
reactivation_time
Specifies the time duration after which the status of the inactive server is rechecked.
reactivation_time
must be an integer from 1 through 1800.
Important:
If not explicitly configured, the default value of 300 seconds will be used.
Usage
Use this command to configure the time duration (in seconds) after which the status of a previously inactive
server is rechecked.
server is rechecked.
Example
The following command configures the reactivation time to
180
seconds:
reactivation-time 180