Cisco Cisco Packet Data Interworking Function (PDIF)
HSS Peer Service Configuration Mode Commands
▀ failure-handling
▄ Command Line Interface Reference, StarOS Release 17
6452
failure-handling
Configures failure handling behavior in the event of a failure with the HSS peer service. It also defines the action on
various error codes on the Diameter interface during authentication or session activities.
various error codes on the Diameter interface during authentication or session activities.
Product
MME
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HSS Peer Service Configuration
configure > context context_name > hss-peer-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-hss-peer-service)#
Syntax
failure-handling { authentication-information-request | check-identity-request| notify-
request | purge-ue-request | update-location-request } { diameter-result-code
start_error_code [ to end_error_code ] | request-timeout } action { continue | retry-and-
terminate | terminate }
request | purge-ue-request | update-location-request } { diameter-result-code
start_error_code [ to end_error_code ] | request-timeout } action { continue | retry-and-
terminate | terminate }
no failure-handling { authentication-information-request | check-identity-request |
notify-request | purge-ue-request | update-location-request } diameter-result-code
start_error_code [ to end_error_code ]
notify-request | purge-ue-request | update-location-request } diameter-result-code
start_error_code [ to end_error_code ]
default failure-handling { authentication-information-request | check-identity-request |
notify-request | purge-ue-request | update-location-request } request-timeout
notify-request | purge-ue-request | update-location-request } request-timeout
no
Removes the preconfigured failure handling procedures for calls in an HSS peer service.
default
Sets the default action for failure handling procedure for calls in an HSS peer service.
For default actions on Diameter result/error codes see the Usage section below.
For default actions on Diameter result/error codes see the Usage section below.
authentication-information-request
Configures the MME-HSS service to handle the failures in an Auth-Information-Request message.
Configures the SGSN-HSS service to handle the failures in an Auth-Information-Request message.
Configures the SGSN-HSS service to handle the failures in an Auth-Information-Request message.
check-identity-request
Configures the MME-HSS service to handle the failures in a Check-Identity-Information-Request message.
Configures the SGSN-HSS service to handle the failures in a Check-Identity-Information-Request message.
Configures the SGSN-HSS service to handle the failures in a Check-Identity-Information-Request message.