Cisco Cisco Packet Data Interworking Function (PDIF)
IPSG RADIUS Snoop Configuration Mode Commands
sess-replacement ▀
Command Line Interface Reference, StarOS Release 17 ▄
6593
sess-replacement
This command allows you to enable/disable session replacement.
Important:
This command is not supported in this release. The Session Replacement feature is under
development for future use.
Product
IPSG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IPSG RADIUS Snoop Configuration
configure > context context_name > ipsg-service service_name mode radius-snoop
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ipsg-service-radius-snoop)#
Syntax
sess-replacement { with-diff-acct-sess-id | with-diff-ip | with-diff-key }
{ default | no } sess-replacement
default
Configures this command with its default setting.
Default: Disabled.
Default: Disabled.
no
If previously configured, deletes the configuration.
with-diff-acct-sess-id
Specifies to replace current session when a new session request comes with same IP address and same user
name/IMSI but different accounting session ID.
name/IMSI but different accounting session ID.
with-diff-ip
Specifies to replace current session when a new session request comes with same user name/IMSI but
different IP address.
different IP address.
with-diff-key
Specifies to replace current session when a new session request comes with same IP address but different user
name/IMSI.
name/IMSI.