Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
check-point accounting ▀
Command Line Interface Reference, StarOS Release 17 ▄
663
check-point accounting
This command configures micro checkpoint syncup timer for ICSR and Session Recovery for Rf-Gy synchronization.
Product
GGSN
P-GW
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
check-point accounting sync-timer { icsr | sr } timer_value [ sr | icsr ] timer_value
no check-point accounting sync-timer { icsr | sr }
no
If the micro checkpoint syncup timer is already configured, then the
no
variant will delete the configuration.
sr timer_value
Configures micro check-pointing timer for Session Recovery (SR). By default, the session recovery check-
pointing will be done on 8 seconds.
pointing will be done on 8 seconds.
timer_value
: Time configured will be in multiples of 2 seconds. Note that the timer value less than 4
seconds and greater than 60 seconds will not be accepted.
icsr timer_value
Configures micro check-pointing timer for ICSR. By default, the ICSR check-pointing will be done on 18
seconds.
seconds.
timer_value
: Time configured will be in multiples of 2 seconds. Note that the timer value less than 4
seconds and greater than 60 seconds will not be accepted.
Usage
Use this command to configure micro checkpoint syncup timer for ICSR and Session Recovery. Micro
Checkpoint Sync-up timer is an internal timer utilized by Rf and Gy modules to check point corresponding
billing information.
Releases prior to 17.0, micro checkpoint sync-up timer was hardcoded with a value of 18 seconds for ICSR
and 8 seconds for Session Recovery (SR). In 17.0 and later releases, the micro checkpoint sync-up timer is
made configurable with an expectation that it be set at a value as low as 4 seconds. The timer value is reduced
to ensure the accurate billing information during the ICSR or SR switchover event.
This CLI is available at both active charging service level and rulebase level. If the timer value is configured
at both service and rulebase level, then the service level value will be overridden with rulebase level values.
Checkpoint Sync-up timer is an internal timer utilized by Rf and Gy modules to check point corresponding
billing information.
Releases prior to 17.0, micro checkpoint sync-up timer was hardcoded with a value of 18 seconds for ICSR
and 8 seconds for Session Recovery (SR). In 17.0 and later releases, the micro checkpoint sync-up timer is
made configurable with an expectation that it be set at a value as low as 4 seconds. The timer value is reduced
to ensure the accurate billing information during the ICSR or SR switchover event.
This CLI is available at both active charging service level and rulebase level. If the timer value is configured
at both service and rulebase level, then the service level value will be overridden with rulebase level values.