Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
egcdr cdr-encoding ▀
Command Line Interface Reference, StarOS Release 17 ▄
685
egcdr cdr-encoding
This command allows you to configure the eG-CDR encoding type.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
egcdr cdr-encoding { ascii [ delimiter { colon | comma | pipe } ] | asn.1 }
default egcdr cdr-encoding
default
Configures the default eG-CDR CDR-encoding format.
Default:
Default:
asn.1
ascii [ delimiter { colon | comma | pipe } ]
Specifies to use ASCII encoding type to generate eG-CDR in ASCII format.
delimiter { colon | comma | pipe }
: Specifies the delimiter character to use in eG-CDRs in ASCII
format.
colon
: Specifies to use “:” (colon) as a delimiter in eG-CDR.
comma
: Specifies to use “,” (comma), as a delimiter in eG-CDR.
pipe
: Specifies to use “|” (pipe) as a delimiter in eG-CDR.
Default:
pipe
asn.1
Specifies to use ASN.1 encoding type to generate eG-CDR in ASN.1 format.
This is the default setting.
This is the default setting.
Usage
Use this command to configure the eG-CDR encoding type.
For more information on using eG-CDR ASCII encoding type in your deployment, contact your Cisco
account representative.
For more information on using eG-CDR ASCII encoding type in your deployment, contact your Cisco
account representative.
Example
The following command specifies to use ASCII encoding type to generate eG-CDR in ASCII format while
specifying the delimiter character as comma:
specifying the delimiter character as comma: