Cisco Cisco Packet Data Interworking Function (PDIF)
LMA Service Configuration Mode Commands
bind address ▀
Command Line Interface Reference, StarOS Release 17 ▄
6861
bind address
Binds the LMA service to a logical IP interface serving as the S2a (HSGW) or S5/S8 (S-GW) interface and specifies the
maximum number of subscribers that can access this service over the configured interface.
maximum number of subscribers that can access this service over the configured interface.
Product
P-GW
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > LMA Service Configuration
configure > context context_name > lma-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-lma-service)#
Syntax
bind address ipv6_address [ ipv4-address ipv4_address ] [ max-subscribers num ]
no bind address
no
Removes the interface binding from this service.
address ipv6_address
Specifies the IPv6 address of the interface configured as the S2a or S5/S8 interface.
ipv6_address
is
specified in colon separated notation.
ipv4-address ipv4_address
Specifies optional IPv4 HA/P-GW address to support DSMIP6 session using IPv4 transport.
ipv4_address
must be entered as a standard IPv4 address in dotted decimal notation.
max-subscribers num
Default: 3000000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
num
must be
configured to an integer between 0 and 3,000,000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active PSCs in the system. A fully loaded system with 13 active PSCs can support 3,000,000 total
subscribers. Refer to the license key command and the Usage section (below) for additional information.
subscribers. Refer to the license key command and the Usage section (below) for additional information.