Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
▀ egcdr time-duration algorithm
▄ Command Line Interface Reference, StarOS Release 17
690
egcdr time-duration algorithm
This command allows you to specify the algorithm to compute the duration of time utilization in an eG-CDR for the
current rulebase.
current rulebase.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
egcdr time-duration algorithm { consumed-time consumed_time [ plus-idle ] | continuous-
time-periods ctp_time | parking-meter seconds }
time-periods ctp_time | parking-meter seconds }
{ default | no } egcdr time-duration algorithm
no
If previously configured, deletes the eG-CDR time-duration algorithm configuration from the current
rulebase.
rulebase.
default
Configures this command with its default setting.
Default: Algorithm configured for CCA, or the CCA default if none is configured.
Default: Algorithm configured for CCA, or the CCA default if none is configured.
consumed-time consumed_time [ plus-idle ]
Specifies the actual consumption time in seconds. This is used to determine the actual used chargeable time
envelopes for the purpose of consuming time quota.
envelopes for the purpose of consuming time quota.
consumed_time
must be an integer from 1 through 4294967295.
Default: 0 (disabled)
Time envelope is the basis for reporting active usage. For each time envelope, the time consumption includes
the time duration between arrival of last packet and first packet only.
Time envelope is the basis for reporting active usage. For each time envelope, the time consumption includes
the time duration between arrival of last packet and first packet only.
plus-idle
: Specifies the idle time between arrival of two packets to include in time usage record in eG-
CDR.
When used along with
When used along with
consumed-time
it indicates the active usage + idle time, when no traffic flow occurs.
continuous-time-periods ctp_time
Specifies the continuous time period to compute the usage record in eG-CDR.
ctp_time
sets the audition, in seconds, to start a counter on arrival of the first packet and thereafter include
only that period in charging in which one or more packets arrived. For the period where no packets arrived or
no traffic was detected, usage will not be computed.
no traffic was detected, usage will not be computed.
ctp_time
must be an integer from 1 through 4294967295.