Cisco Cisco Packet Data Interworking Function (PDIF)
Location Service Configuration Mode Commands
▀ destination-host
▄ Command Line Interface Reference, StarOS Release 17
6948
destination-host
Configures the host name of the GLMC to be used for this Location service. When defined, this host name is populated
in the destination-host AVP.
in the destination-host AVP.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > Location Service Configuration
configure > context context_name > location-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-location-service)#
Syntax
destination-host destination_host
no destination-host
no
Removes the configured destination host.
destination_host
Defines the host name to be used for be a string from 1 to 63 characters.
Usage
To comply with 3GPP TS29.172, the Destination-Host AVP is sent to the GMLC for all the Location Report
Request (LRR) messages initiated by MME.
Use this command to configure the destination-host AVP for this Location service.
If this command is not configured, the peer host name configured in the diameter endpoint is encoded as
destination-host AVP. Refer to the
Request (LRR) messages initiated by MME.
Use this command to configure the destination-host AVP for this Location service.
If this command is not configured, the peer host name configured in the diameter endpoint is encoded as
destination-host AVP. Refer to the
peer
command in the Diameter Endpoint Configuration Mode.