Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
firewall policy ▀
Command Line Interface Reference, StarOS Release 17 ▄
709
firewall policy
This command allows you to enable/disable Stateful Firewall support for all subscribers using the current rulebase.
Important:
In StarOS 8.0, this command is available in the APN/Subscriber Configuration Mode. In StarOS 8.1
and StarOS 8.3, use this command for Rulebase-based Firewall-and-NAT configuration. In StarOS 8.1 and StarOS 9.0
and later releases, for Policy-based Firewall-and-NAT configuration, this command is available in the Firewall-and-
NAT Policy Configuration Mode.
and later releases, for Policy-based Firewall-and-NAT configuration, this command is available in the Firewall-and-
NAT Policy Configuration Mode.
Product
PSF
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
firewall policy firewall-required
{ default | no } firewall policy
default
Configures this command with its default setting.
Default: Stateful Firewall support is disabled for all subscribers using the current rulebase.
Default: Stateful Firewall support is disabled for all subscribers using the current rulebase.
no
If previously enabled, disables Stateful Firewall support for all subscribers using the current rulebase.
firewall-required
Enables Stateful Firewall support for all subscribers using the current rulebase.
Usage
Use this command to enable/disable Stateful Firewall support for all subscribers using the current rulebase.
Example
The following command enables Stateful Firewall support:
firewall policy firewall-required
The following command disables Stateful Firewall support:
no firewall policy