Cisco Cisco Packet Data Interworking Function (PDIF)
OSPF Configuration Mode Commands
▀ area stub
▄ Command Line Interface Reference, StarOS Release 17
7444
area stub
Defines an area as an OSPF stub area.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > OSPF Configuration
configure > context context_name > router ospf
Entering the above command sequence results in the following prompt:
[local]host_name(config-ospf)#
Syntax
[ no ] area { ip_address | decimal_value } stub [ no-summary ]
ip_address
Specifies the IP address of the stub area in IPv4 dotted-decimal notation.
decimal_value
Specifies the identification number of the stub area as an integer from 0 through 4294967295.
stub
Specifies this is a stub area.
no-summary
Disables (stops) the ABR (Area Border Router) from sending summary link state advertisements (LSAs) into
the stub area.
the stub area.
Usage
Use this command to define an OPSF area as a stub area.
Example
The following command defines the OSPF area defined by the IP address
192.168.100.10
as a stub area:
area 192.168.100.10 stub