Cisco Cisco Packet Data Interworking Function (PDIF)
Policy Control Configuration Mode Commands
diameter request-timeout ▀
Command Line Interface Reference, StarOS Release 17 ▄
7997
diameter request-timeout
This command configures the request-timeout setting for Diameter-IMSA Gx interface.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IMS Authorization Configuration > Policy Control
Configuration
Configuration
configure > context context_name > ims-auth-service service_name > policy-control
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-imsa-dpca)#
Syntax
diameter request-timeout timeout
default diameter request-timeout
timeout
Specifies the timeout duration (in seconds). The value must be an integer from 1 through 300.
Default: 10 seconds
Default: 10 seconds
default
Applies the default setting for this command.
Usage
Use this command to configure the request-timeout setting for Diameter-IMSA Gx interface. At the request-
timeout value, DPCA will apply failure-handling to the subscriber. Action will be taken based on the failure-
handling configuration (terminate/retry-terminate/continue).
timeout value, DPCA will apply failure-handling to the subscriber. Action will be taken based on the failure-
handling configuration (terminate/retry-terminate/continue).
Example
The following command configures the Diameter request-timeout setting to
20
seconds:
diameter request-timeout 20