Cisco Cisco Packet Data Interworking Function (PDIF)
Session Trace Template Configuration Mode Commands
▀ target-ne
▄ Command Line Interface Reference, StarOS Release 17
8400
target-ne
This command initiates tracing towards other network elements.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Session Trace Template Configuration
configure > template-session-trace network-element { { enb template-name cell-trace } | {
{ ggsn | hnbgw | mme | pgw | saegw | sgw } template-name template_name } }
{ ggsn | hnbgw | mme | pgw | saegw | sgw } template-name template_name } }
Entering the above command sequence results in the following prompt:
[local]host_name(config-sesstrc-template)#
Syntax
[ no ] target-ne { all | { enb | pgw | sgw } [ target-interface interface_name ] }
no
Disables its following configured options.
all
Selects all interfaces supported under MME for session trace.
target-interface interface_name
Specifies the interface for the selected Network Element for tracing.
Available
target-interface
options for
enb
are as follows:
all
s1mme: Specifies that the interface where the trace will be performed is the S1-MME interface
between the MME and the eNodeB.
uu: Specifies that the interface where the trace will be performed is the UU interface between
the MME and the eNodeB.
x2: Specifies that the interface where the trace will be performed is the X2 interface between
the MME and the eNodeB.
Available
target-interface
options for
pgw
are as follows:
all
gx: Specifies that the interface where the trace will be performed is the Gx interface between
the P-GW and the PCRF.
s2a: Specifies that the interface where the trace will be performed is the S2a interface between
the PGW and the HSGW.