Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Ruledef Configuration Mode Commands
http transaction-length ▀
Command Line Interface Reference, StarOS Release 17 ▄
899
http transaction-length
This command allows you to define rule expressions to match HTTP transaction length (combined length of one HTTP
GET Request message and its associated response messages).
GET Request message and its associated response messages).
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] http transaction-length { operator transaction_length | { { range | !range }
range_from to range_to } }
range_from to range_to } }
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
transaction_length
Specifies the HTTP transaction length (in bytes) to match.
transaction_length
must be an integer from 1 through 4000000000.
{ range | !range } range_from to range_to
Enables or disables the range criteria for length of transaction.
range
: Enables the range criteria for HTTP transaction length.
!range
: Disables the range criteria for HTTP transaction length.
range_from
: Specifies the start of range (in bytes) for HTTP transaction length.
range_to
: Specifies the end of range (in bytes) for HTTP transaction length.