Cisco Cisco Packet Data Gateway (PDG)
Command Line Interface Reference, StarOS Release 16 ▄
1521
Chapter 25
APN Remap Table Configuration Mode
APN Remap Table Configuration mode provides the commands to configure parameters for multiple features related to
Access Point Name (APN) handling, such as: Default APN, APN Remap, and Wildcard APN. APN remap table is a key
element of the Operator Policy feature and a table is not usable (valid) until it has been associated with an operator
policy (see the Operator Policy Configuration Mode Commands ) or an IMEI profile (see the IMEI Profile
Configuration Mode Commands).
Access Point Name (APN) handling, such as: Default APN, APN Remap, and Wildcard APN. APN remap table is a key
element of the Operator Policy feature and a table is not usable (valid) until it has been associated with an operator
policy (see the Operator Policy Configuration Mode Commands ) or an IMEI profile (see the IMEI Profile
Configuration Mode Commands).
Important:
Beginning with Release 16 for SGSN only, an APN Remap Table associated with an IMEI profile
overrides a remap table associated with an operator policy. This means activation will be rejected if a local default APN
configured, in an APN Remap Table associated with an IMEI profile, cannot be used. This will occur even if a valid
local default APN is available in an APN Remap Table associated with an operator policy.
configured, in an APN Remap Table associated with an IMEI profile, cannot be used. This will occur even if a valid
local default APN is available in an APN Remap Table associated with an operator policy.
A maximum of 1,000 APN remap tables are supported, and each APN remap table supports a maximum of 100 APN
remap entries. Multiple tables can be defined and stored but an operator policy and/or IMEI profile each only support
association with a single (one) table per policy/profile configuration. The APN remap table associated with an IMEI
profile will be used in IMEI override scenarios.
remap entries. Multiple tables can be defined and stored but an operator policy and/or IMEI profile each only support
association with a single (one) table per policy/profile configuration. The APN remap table associated with an IMEI
profile will be used in IMEI override scenarios.
Mode
Exec > Global Configuration > APN Remap Table Configuration
configure > apn-remap-table table_name
Entering the above command sequence results in the following prompt:
[local]host_name(apn-remap-table_name)#
Important:
The commands or keywords/variables that are available are dependent on platform type, product
version, and installed license(s).